Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Asus VivoBook X540SA-BPD0602V Battery Removal

Cosa ti serve

  1. Asus VivoBook X540SA-BPD0602V Battery Removal, Keyboard: passo 1, immagine 1 di 1
    • Power down the laptop using the device's power button in top right corner of the keyboard. Ensure that the device's power cord is disconnected.

  2. Asus VivoBook X540SA-BPD0602V Battery Removal: passo 2, immagine 1 di 1
    • Flip the laptop over so the back panel is displayed.

  3. Asus VivoBook X540SA-BPD0602V Battery Removal: passo 3, immagine 1 di 1
    • Using a Phillips #1 screwdriver, remove the ten screws from the back panel.

    • Remove the two battery screws (15.6 mm)

    • Two top corner screws (12.5 mm)

    • Six case screws (9.7mm)

  4. Asus VivoBook X540SA-BPD0602V Battery Removal: passo 4, immagine 1 di 1
    • Flip the laptop back over and open it, revealing the screen and keyboard.

  5. Asus VivoBook X540SA-BPD0602V Battery Removal: passo 5, immagine 1 di 1
    • Using the blue plastic opening tool, wedge and loosen the seal all the way around the edges. Carefully lift up the keyboard panel.

    • When lifting the keyboard panel, do not lift it all the way as the two connection ribbons to the motherboard must be disconnected.

    • It is recommended to break the seal of the case starting at the upper corners closest to the display monitor .

  6. Asus VivoBook X540SA-BPD0602V Battery Removal: passo 6, immagine 1 di 1
    • Observe where the ribbons connect to the motherboard, there are two connections. Each connection has a black clamp. To remove the ribbon, lift the black clamp up to disconnect it.

  7. Asus VivoBook X540SA-BPD0602V Battery Removal, Battery: passo 7, immagine 1 di 1
    • Very carefully, remove the batteries with the same blue plastic iFixit opening tool used in the first tutorial. Focus your efforts on the combed hinge to the left of the batteries.

    • The batteries should all be connected to one another and come out of the device as a single unit.

    • Be careful not to rip any of the black plastic covering the batteries. Exposed battery parts can lead to explosions. If the case is ripped, re-wrap them, or properly dispose of them. Do not use them.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Team

USF Tampa, Team S1-G111, Cagle Fall 2017 Membro di USF Tampa, Team S1-G111, Cagle Fall 2017

USFT-CAGLE-F17S1G111

5 Membri

14 Guide realizzate

Un commento

Easy, and nice guide.
To be honest you don't need make pint 6 - unplug keyboard and pad cable. You can just move cover a bit to your side (pull into your direction) then you will get a lot space to pull out battery.

Damian Gepard - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 14

Ultimi 30 Giorni: 73

Tutti i Tempi: 9,319