Parti

Nessuna parte richiesta.

Flip the computer over so that it is upside down.
  • Flip the computer over so that it is upside down.

  • Slide both latches away from each other (towards the outside).

  • Push the battery out with your fingers.

  • The actual battery is not shown in the photograph.

Aggiungi Commento

Remove screws highlighted on the picture.
  • Remove screws highlighted on the picture.

  • Once the screws are removed, pry open the panel with the pry tool.

  • It should now look like this.

Aggiungi Commento

  • After removing that panel, locate the screw on the right as highlighted.

  • Remove that screw.

  • Pry open the side panel with the small prying tool as shown.

  • That panel should pop off and the wireless card will now be easily visible.

Aggiungi Commento

  • Place the small prying tool underneath the gold connector, apply pressure straight up, gently until it pops off.

  • Repeat for the other one.

  • Push them aside.

Aggiungi Commento

  • Locate tabs that are holding the wireless card in place. Highlighted in picture.

  • Place one finger on each tab and press each to the side away from the wireless card as shown.

  • The wireless card should pop up as shown. Pull up more with fingers to get more clearance.

Aggiungi Commento

  • To remove the wireless card, pull the card directly out.

  • It should come out with just a little bit of pressure.

  • Should look as shown when removed.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Steven

Membro da: 24/06/2010

32 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 2-9, Johann Summer 2010 Membro di Cal Poly, Team 2-9, Johann Summer 2010

CPSU-JOHANN-R10S2G9

5 Membri

11 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 3,675