Salta al contenuto principale

Introduzione

Issues with the ports on the left side of the laptop can indicate that the IO board is in need of replacement. Follow this step by step guide to replace it yourself.

  1. Remove the back 6mm and 8mm screws with a J000 screwdriver. Remove the back 6mm and 8mm screws with a J000 screwdriver.
    • Remove the back 6mm and 8mm screws with a J000 screwdriver.

  2. Remove the back cover of the flip book by gently using a metal spudger. Remove the back cover of the flip book by gently using a metal spudger.
    • Remove the back cover of the flip book by gently using a metal spudger.

  3. Unscrew the battery from the motherboard using a J000 screwdriver on the 3mm screws.
    • Unscrew the battery from the motherboard using a J000 screwdriver on the 3mm screws.

  4. Skip the upgrade.

    Ottieni $10 di sconto su $50 con
    SKIPANDSAVE10

    Save Now

    Skip the upgrade.

    Take $10 off $50 with
    SKIPANDSAVE10

    Save Now
  5. The battery comes attached to the motherboard and needs to be disconnected before you can remove it. Disconnect the battery from the motherboard by gently pulling out the connection with tweezers.
    • The battery comes attached to the motherboard and needs to be disconnected before you can remove it.

    • Disconnect the battery from the motherboard by gently pulling out the connection with tweezers.

  6. The IO Board will be the section of circuitry to the left. It's held down by a couple of 3mm and 6mm screws and some device connections. Unscrew the 3mm and 6mm screws on the IO Board with a phillips head J000 screwdriver.
    • The IO Board will be the section of circuitry to the left. It's held down by a couple of 3mm and 6mm screws and some device connections.

    • Unscrew the 3mm and 6mm screws on the IO Board with a phillips head J000 screwdriver.

  7. After unscrewing, gently unplug all the connections to the IO Board with tweezers. We have highlighted where these connections are located in our images. After unscrewing, gently unplug all the connections to the IO Board with tweezers. We have highlighted where these connections are located in our images. After unscrewing, gently unplug all the connections to the IO Board with tweezers. We have highlighted where these connections are located in our images.
    • After unscrewing, gently unplug all the connections to the IO Board with tweezers. We have highlighted where these connections are located in our images.

  8. Remove the final connections from the IO board with tweezers. Remove the final connections from the IO board with tweezers.
    • Remove the final connections from the IO board with tweezers.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Alejandro Lopez

Membro da: 15/02/2018

635 Reputazione

5 Guide realizzate

Team

USF Tampa, Team S17-G2, Boczar Spring 2018 Membro di USF Tampa, Team S17-G2, Boczar Spring 2018

USFT-BOCZAR-S18S17G2

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 8

Tutti i Tempi: 253