Salta al contenuto principale

Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.

Cosa ti serve

  1. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 1, immagine 1 di 1
    • Flip the netbook over.

    • Be sure to unplug the netbook and power off the device while working.

  2. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 2, immagine 1 di 1
    • Push open both tabs on either side of the battery.

    • The tab on the left will click open and stay in place until you close it.

  3. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 3, immagine 1 di 1
    • Pull the tab on the right open, while you remove battery with your other hand.

    • Pull the battery straight out ensuring that you don't damage any connectors.

  4. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 4, immagine 1 di 2 : passo 4, immagine 2 di 2
    • Remove the six screw on the front cover by using the plastic opening tool. Then, remove the six 4.6mm screws using the J0 Phillips head screwdriver.

  5. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 5, immagine 1 di 1
    • Using the plastic opening tool, separate the over from the netbook.

  6. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 6, immagine 1 di 1
    • You must separate the hinge cover from the cover before removing the cover.

  7. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 7, immagine 1 di 1
    • After removing the cover, remove the two 4.6mm screws using the J0 Phillips head screwdriver.

  8. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 8, immagine 1 di 1
    • There are two screws on the left and right side of the display. Remove all four 3mm screws using the J0 Phillips head to separate the LCD from the display cover.

    • The left side will have a magnet covering the bottom screw remove the magnet. Be sure to replace when reassembling.

  9. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 9, immagine 1 di 1
    • Pull up on the video cable on the back of the LCD display to remove it.

Linea Traguardo

Un'altra persona ha completato questa guida.

Mohamed Al Mardhouf Al Saadi

Membro da: 10/04/16

133 Reputazione

1 Guida realizzata

Team

USF Tampa, Team 2-3, Nance Fall 2016 Membro di USF Tampa, Team 2-3, Nance Fall 2016

USFT-NANCE-F16S2G3

4 Membri

12 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 590