Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a plastic opening tool to pull up the four metal latches in the battery cavity that is located on the bottom of the laptop.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the laptop over, and open the display.
-
Use a plastic opening tool to lift the edge of the keyboard that is nearest to the screen.
-
Gently lift the keyboard and slide it toward the screen.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger tool to release the tabs on the ribbon cable ZIF connector that is attached to the underside of the keyboard.
-
Once the ZIF connector tabs have been released, remove the keyboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the laptop over.
-
Using a Phillips #1 screwdriver, remove the five 5.65 mm screws.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the lid to the RAM compartment, if possible.
-
To remove the RAM, depress the tabs that are holding it in. These tabs are bound in red in the picture.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips #1 screwdriver to remove one 6.5 mm screw located next to the RAM.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the laptop back over, and open the display.
-
Use a Phillips #1 screwdriver to remove the six 5.5 mm screws on the inside covering.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Detach the five plastic clips holding the upper and lower halves of the laptop together. These can be undone by carefully running a plastic opening tool between the top and bottom casing. There will be an audible audible "click" as the clips come undone.
-
Once the five clips have been undone, carefully remove the upper half of the laptop.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Detach the track pad ribbon by using a plastic opening tool to raise up the black pad.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Detach the Bluetooth wire located below the fan by gently pulling it upward.
-