Salta al contenuto principale

Astak Mole Antenna Replacement

Cosa ti serve

  1. Astak Mole Antenna Replacement, Lower Case: passo 1, immagine 1 di 1
    • Remove the four bottom tabs in order to access the bottom screws.

  2. Astak Mole Antenna Replacement: passo 2, immagine 1 di 1
    • Remove all four 14 mm Phillips #1 screws.

  3. Astak Mole Antenna Replacement: passo 3, immagine 1 di 1
    • Remove the SD card.

  4. Astak Mole Antenna Replacement: passo 4, immagine 1 di 1
    • Pry up the motherboard on the four points using a spudger.

    • The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

  5. Astak Mole Antenna Replacement: passo 5, immagine 1 di 1
    • Gently pull back the motherboard to expose many of the component's wired connections.

  6. Astak Mole Antenna Replacement, Antenna: passo 6, immagine 1 di 2 Astak Mole Antenna Replacement, Antenna: passo 6, immagine 2 di 2
    • Unscrew the antenna in a counter-clockwise rotation.

  7. Astak Mole Antenna Replacement: passo 7, immagine 1 di 1
    • Take out the screw holding the antenna wire with the PH1 size Phillips head bit.

    • Screw length: 5.3mm

  8. Astak Mole Antenna Replacement: passo 8, immagine 1 di 1
    • Gently pry open the circuit board attached to the antenna wire using a metal spudger.

    • The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

  9. Astak Mole Antenna Replacement: passo 9, immagine 1 di 1
    • Remove the antenna female end from the motherboard.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

USF Tampa, Team 2-2, Blackwell Fall 2016 Membro di USF Tampa, Team 2-2, Blackwell Fall 2016

USFT-BLACKWELL-F16S2G2

4 Membri

12 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 6

Ultimi 30 Giorni: 11

Tutti i Tempi: 445