Introduzione

This repair will need:

A T8 Torx Screwdriver.

Parti

Nessuna parte richiesta.

  1. With the Generally Disassembly completed, you may proceed to floppy drive installation.
    • With the Generally Disassembly completed, you may proceed to floppy drive installation.

    Aggiungi Commento

  2. Remove the plastic panel at the bottom of the display.
    • Remove the plastic panel at the bottom of the display.

    Aggiungi Commento

    • Reverse the computer to access the peripheral panel in the back.

    • Remove the two T8 Torx screws on either side of the bar code panel.

    Aggiungi Commento

  3. Spedizione gratuita per ordini superiori a $20
    Usa il codice BLUEANDBLACK al checkout
    Spedizione gratuita per ordini superiori a $20
    Usa il codice BLUEANDBLACK
    • Reverse the computer to have the monitor and mousepad facing you.

    • Remove the plastic panel underneath the display.

    Aggiungi Commento

    • Remove the three T8 Torx screws securing the floppy drive to the frame.

    Aggiungi Commento

    • Using a spudger, lift the plastic tabs on the floppy drive securing the ribbon cable to the ribbon port.

    Aggiungi Commento

    • Lift the defective floppy drive from the body of the computer.

    Aggiungi Commento

    • Replace the defective drive with a new drive.

    • Follow these instructions in reverse order to reassemble the device.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Kevin Peters

Membro da: 19/04/2011

114 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 20-66, Walters Spring 2011 Membro di Cal Poly, Team 20-66, Walters Spring 2011

CPSU-WALTERS-S11S20G66

4 Membri

3 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 5

Tutti i Tempi: 2,068