Introduzione

Replace a faulty antenna on the AirPort Extreme Model A1034.

Parti

Nessuna parte richiesta.

Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.
  • Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.

Aggiungi Commento

Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.
  • Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.

Aggiungi Commento

  • Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.

Aggiungi Commento

  • Unplug the black connector on the top of the metal casing by gently pulling horizontally.

Aggiungi Commento

  • Remove the two 4mm phillips screws to remove antenna.

Aggiungi Commento

  • The circuit board connected to the antenna is attached to the metal case with foam adhesive.

  • Gently peel or cut the foam holding the circuit board with a knife and remove it from the AirPort.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Michael Garcia

Membro da: 12/10/2011

369 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 17-15, Regan Fall 2011 Membro di Cal Poly, Team 17-15, Regan Fall 2011

CPSU-REGAN-F11S17G15

3 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 11

Tutti i Tempi: 4,055