Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the stickers from the bottom of the mouse to have access to the screws, The stickers are shown in the picture by the red rectangles.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips #00 to remove the 4 screws shown by the red circles in the picture.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a plastic opening tool or spudger, on the center of the mouse, separate the upper and lower board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the wires from the white crimp headers, separating the upper and lower housing units of the mouse. Avoid pulling the wires too hard to prevent them from breaking.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the scroll wheel put parallel to the board.
-
Replace/clean if needed.
-
If your mouse still does not work after this step, then continue to the next instruction.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Desolder the three pins, then solder in the replacement part.
-
Un commento
Hi Vincent, could you please help me with finding a place where this rotation sensor can be bought. I'm not even sure how this part is called so searching for it is quite tricky.
Cheers,
Michal