Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Gira il telecomando a faccia in giù e appoggia l'indice sull'aletta. Premila delicatamente per aprire il vano batterie.
-
Solleva la copertura delle batterie per accedere alle batterie.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the four 3.6 mm Phillips J#00 screws found under the back panel of the remote control and remove them.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the bottom of the remote control.
-
Place your thumb on the bottom part of the remote. Apply pressure as shown in the picture to release the back panel from the front of the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert a plastic opening tool in the gap and apply some force to disconnect the two pieces away from each other.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the seven 2.4 mm Phillips J#00 screws that connect the motherboard to the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the plastic opening tool or your fingernail in the gap at the top end and lift the motherboard.
-
Annulla: non ho completato questa guida.
Altre 5 persone hanno completato questa guida.
3 Commenti
Hello,
step 5 is wrong! There are no pins but screws!
You need to disconnect the upper piece (infrared sensor) first. Underneath you will find two more screws. Then you can open the case easily.
The circuit board can not be fixed instead of replaced. Understand might be cheaper to replace
This was useful to me to find a location I could attach a lanyard to the remote. It is so small it keeps disappearing.