Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel off the rubber footing from the bottom of the Echo.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 42.8 mm T10 Torx screws from the bottom of the Echo.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slowly lift the plate containing the board. Be careful not to disconnect any of the wires.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Tweezers$4.99-
Using tweezers, carefully disconnect the two red and black cables from their sockets on the board.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the brown plastic latch on the ZIF connector securing the driver board ribbon cable.
-
Pull the ribbon cable from its connector. The plate and board should now be free from the Echo.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the spudger, pull back the two plastic clips on the plate.
-
Lift the board up and pull it away from the plate.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the plastic plate from the bottom of the device. Then remove the plastic shrouding.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel off the black fabric wrapped around the Echo.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 42.8 mm T10 Torx screws around the tweeter.
-
Lift the tweeter and its attached housing from the device.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.
3 Commenti
Where can you buy a replacement woofer?
My exact question.