Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

Use this guide to replace the 4-in-1 WiFi/Bluetooth/FM/GPS board on the Amazon Echo Dot 2nd generation. The 4-in-1 is located on the motherboard, so the whole board must be replaced, rather than replacing each individual component.

  1. Power off and unplug the echo Using the plastic opening tool, peel off the rubber layer on the bottom of the echo Using the plastic opening tool, peel off the rubber layer on the bottom of the echo
    • Power off and unplug the echo

    • Using the plastic opening tool, peel off the rubber layer on the bottom of the echo

  2. Use a T8 screwdriver bit to unscrew the four 1.6mm torx screws Remove the black cylindrical base Remove the black cylindrical base
    • Use a T8 screwdriver bit to unscrew the four 1.6mm torx screws

    • Remove the black cylindrical base

  3. SKIP THE UPGRADE

    Save by fixing with an all-in-one kit.

    Shop iPhone Fix Kits

    SKIP THE UPGRADE

    Save by fixing with an all-in-one kit.

    Shop iPhone Fix Kits
  4. Use the metal spudger to lift the ZIF connector Remove the ribbon cable from the slot Remove the ribbon cable from the slot
    • Use the metal spudger to lift the ZIF connector

    • Remove the ribbon cable from the slot

  5. Remove the motherboard
    • Remove the motherboard

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 5 persone hanno completato questa guida.

Alexis White

Membro da: 09/10/2017

366 Reputazione

2 Guide realizzate

Team

USF Tampa, Team S1-G3, Leahy Fall 2017 Membro di USF Tampa, Team S1-G3, Leahy Fall 2017

USFT-LEAHY-F17S1G3

3 Membri

10 Guide realizzate

Where can I find the part my dot won’t connect and I have been going crazy trying to find the motherboard

IT's Tech - Replica

I wish to recommend not removing the adhesive layer if you plan to reassemble this Echo Dot. I would suggest poking holes to reach the four screws instead. Then reassembly can reuse the same adhesive layer.

rayramirez - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 5

Ultimi 7 Giorni: 22

Ultimi 30 Giorni: 124

Tutti i Tempi: 4,107