Altec Lansing inMotion iM9 Woofer Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

The woofer is the part of the speaker that outputs lower frequency sounds. Replacement of the woofer requires removal of the batteries, the volume and power buttons, and motherboard. Soldering skills are required; take a look at this soldering guide for extra help.

Cosa ti serve

Passo 1 Battery

Altec Lansing inMotion iM9 Woofer Replacement, Battery: passo 1, immagine 1 di 1

Gently push down on the two tabs at the top of the battery door.
While holding them down, slowly pull the door towards you.

Traduci

Passo 2

Once the door is open, use your hand to pull out the four batteries.

Traduci

Passo 3 Volume and Power Buttons

Altec Lansing inMotion iM9 Woofer Replacement, Volume and Power Buttons: passo 3, immagine 1 di 2

Altec Lansing inMotion iM9 Woofer Replacement, Volume and Power Buttons: passo 3, immagine 2 di 2

Pry off the control panel on top of the speaker using the metal spudger. You may need to use a lot of force.
Start in the middle and work your way around the perimeter.

Traduci

Passo 4

Using a Phillips #1 screwdriver, remove the two 7mm screws that hold the volume button circuit board to the control panel.
Also remove the single 7mm screw from the power button circuit board on the opposite side.
There will be a little plastic piece under the eject button that you can just remove and set aside.

Traduci

Passo 5

Desolder the three solders joints connecting the wires to the volume button circuit board.
Do the same to the power button circuit board on the other side (the board with only one screw).
Pull out the wires using a lot of force.
If you are not familiar or comfortable with soldering, use this guide

Traduci

Passo 6 Case Opening

Altec Lansing inMotion iM9 Woofer Replacement, Case Opening: passo 6, immagine 1 di 2

Altec Lansing inMotion iM9 Woofer Replacement, Case Opening: passo 6, immagine 2 di 2

Gently pry open the silver plastic lining of the iPod dock using the plastic spudger.
It is best to start from the top or bottom, then work your way around if it has not popped out yet.
Remove the silver lining.

Traduci

Passo 7

Pry open the metal mesh by working the plastic spudger around the inside of the mesh.
Once loose, lift up the metal mesh.

Traduci

Passo 8

Remove the fourteen 30mm screws with Phillips #1 Screwdriver.
Remove the 7mm screw with the Phillips #1 Screwdriver.

Traduci

Passo 9

Carefully separate the front and back case plates at a corner of the speaker.
Lots of cables are still connected, so be very gentle when separating case plates.

Traduci