Aggiusta la tua roba Comunità Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Altec Lansing inMotion iM9 Volume and Power Buttons Replacement

Introduzione

In this guide, you will pry off the control panel to unscrew and desolder the circuit boards. If you are not comfortable with soldering, you can use this guide.

Cosa ti serve

  1. Altec Lansing inMotion iM9 Volume and Power Buttons Replacement, Battery: passo 1, immagine 1 di 1

    • Gently push down on the two tabs at the top of the battery door.

    • While holding them down, slowly pull the door towards you.

    Traduci

  2. Altec Lansing inMotion iM9 Volume and Power Buttons Replacement: passo 2, immagine 1 di 1

    • Once the door is open, use your hand to pull out the four batteries.

    Traduci

  4. Altec Lansing inMotion iM9 Volume and Power Buttons Replacement, Volume and Power Buttons: passo 3, immagine 1 di 2 Altec Lansing inMotion iM9 Volume and Power Buttons Replacement, Volume and Power Buttons: passo 3, immagine 2 di 2

    • Pry off the control panel on top of the speaker using the metal spudger. You may need to use a lot of force.

    • Start in the middle and work your way around the perimeter.

    Traduci

  5. Altec Lansing inMotion iM9 Volume and Power Buttons Replacement: passo 4, immagine 1 di 2 Altec Lansing inMotion iM9 Volume and Power Buttons Replacement: passo 4, immagine 2 di 2

    • Using a Phillips #1 screwdriver, remove the two 7mm screws that hold the volume button circuit board to the control panel.

    • Also remove the single 7mm screw from the power button circuit board on the opposite side.

    • There will be a little plastic piece under the eject button that you can just remove and set aside.

    Traduci

  6. Altec Lansing inMotion iM9 Volume and Power Buttons Replacement: passo 5, immagine 1 di 2 Altec Lansing inMotion iM9 Volume and Power Buttons Replacement: passo 5, immagine 2 di 2

    • Desolder the three solders joints connecting the wires to the volume button circuit board.

    • Do the same to the power button circuit board on the other side (the board with only one screw).

    • Pull out the wires using a lot of force.

    • If you are not familiar or comfortable with soldering, use this guide

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 4 altri collaboratori

Ben Toland

Membro da: 02/01/15

101 Reputazione

1 Guida realizzata

Distintivi: 5

+2 altri distintivi

Team

Cal Poly, Team 17-33, Amido Winter 2015 Membro di Cal Poly, Team 17-33, Amido Winter 2015

CPSU-AMIDO-W15S17G33

4 Membri

7 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 2,449