Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Altec Lansing inMotion iM9 Case Opening Replacement

Solo Prerequisita
Questa guida รจ destinata a essere usata solo come prerequisito per altre guide. Da sola รจ incompleta.

Cosa ti serve

  1. Altec Lansing inMotion iM9 Case Opening Replacement, Battery: passo 1, immagine 1 di 1
    • Gently push down on the two tabs at the top of the battery door.

    • While holding them down, slowly pull the door towards you.

  2. Altec Lansing inMotion iM9 Case Opening Replacement: passo 2, immagine 1 di 1
    • Once the door is open, use your hand to pull out the four batteries.

  3. Altec Lansing inMotion iM9 Case Opening Replacement, Case Opening: passo 3, immagine 1 di 2 Altec Lansing inMotion iM9 Case Opening Replacement, Case Opening: passo 3, immagine 2 di 2
    • Gently pry open the silver plastic lining of the iPod dock using the plastic spudger.

    • It is best to start from the top or bottom, then work your way around if it has not popped out yet.

    • Remove the silver lining.

  4. Altec Lansing inMotion iM9 Case Opening Replacement: passo 4, immagine 1 di 2 Altec Lansing inMotion iM9 Case Opening Replacement: passo 4, immagine 2 di 2
    • Pry open the metal mesh by working the plastic spudger around the inside of the mesh.

    • Once loose, lift up the metal mesh.

  5. Altec Lansing inMotion iM9 Case Opening Replacement: passo 5, immagine 1 di 1
    • Remove the fourteen 30mm screws with Phillips #1 Screwdriver.

    • Remove the 7mm screw with the Phillips #1 Screwdriver.

  6. Altec Lansing inMotion iM9 Case Opening Replacement: passo 6, immagine 1 di 1
    • Carefully separate the front and back case plates at a corner of the speaker.

    • Lots of cables are still connected, so be very gentle when separating case plates.

  7. Altec Lansing inMotion iM9 Case Opening Replacement: passo 7, immagine 1 di 1
    • Guide the white button cables through the hole on the top of speaker case.

  8. Altec Lansing inMotion iM9 Case Opening Replacement: passo 8, immagine 1 di 1
    • Use your fingers to peel the glue off of the red and black cables.

  9. Altec Lansing inMotion iM9 Case Opening Replacement: passo 9, immagine 1 di 1
    • Careful not to touch the green capacitors or you might shock yourself.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Johnson Zhou

Membro da: 02/02/15

240 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 17-33, Amido Winter 2015 Membro di Cal Poly, Team 17-33, Amido Winter 2015

CPSU-AMIDO-W15S17G33

4 Membri

7 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 62