Introduzione

Use this guide to replace the motherboard in your Altec Lansing Mini Lifejacket 2 if the bluetooth chip, microphone, or another electronic component has failed.

  1. Use the spudger to remove the eight black pins from the front and back of the wire screens.
    • Use the spudger to remove the eight black pins from the front and back of the wire screens.

    Aggiungi Commento

  2. Detach the eight secondary pins from the front and back of the wire mesh plates with a spudger.
    • Detach the eight secondary pins from the front and back of the wire mesh plates with a spudger.

    • Removing the secondary pins from the rubber casing is optional.

    Aggiungi Commento

    • Remove both black and orange layers from the speaker body.

    Aggiungi Commento

    • Remove the single 7.8mm Phillips #2 screw from the mounting plate located under the device.

    • Slide the mounting plate out to remove it.

    Aggiungi Commento

    • Pry off the wire mesh on both sides using a metal spudger.

    • Be gentle to avoid bending the mesh.

    Aggiungi Commento

    • Using tweezers, remove the four rubber stoppers in each corner of the rear panel.

    Aggiungi Commento

    • Remove the four 13.7mm Phillips #1 screws located underneath the rubber stoppers.

    Aggiungi Commento

    • Pull the case apart to access the interior components.

    Aggiungi Commento

    • To remove the back panel, gently pull out its wire harness.

    Aggiungi Commento

    • Disconnect the battery from the motherboard.

    • The battery is not secured within the case and can be removed after detaching its wiring from the circuit board.

    Aggiungi Commento

    • Unplug the remaining four wire harnesses attached to the circuit board

    Aggiungi Commento

    • Remove the three 9.1mm Phillips #1 screws located on the circuit board.

    Aggiungi Commento

    • Remove the motherboard.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

USF Tampa, Team S3-G2, Nance Spring 2018 Membro di USF Tampa, Team S3-G2, Nance Spring 2018

USFT-NANCE-S18S3G2

4 Membri

4 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 7

Ultimi 7 Giorni: 14

Ultimi 30 Giorni: 66

Tutti i Tempi: 529