Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Starting from any side, use your fingers to grab the black rubber sleeve and gently pull away from the speaker on both sides.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using your fingers, grab the blue sleeve from one side and pull away from the unit.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
At each of the marked pry spots, use the metal spudger to lift the speaker grill away from the case.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Tweezers$4.99-
Use the tweezers to remove the six rubber stoppers. There are four in the middle and two on the sides.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the PH1 Phillips screwdriver to remove the six 12mm screws that lie underneath each rubber stopper.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently pull apart the front panel from the base of the speaker.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The battery will be in the middle of the speaker when the case is open.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull firmly from both sides of the pin to disconnect the battery cable from the motherboard.
-
Pull battery up and away from speaker without catching any other components.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.