Alpine MRV-M500 Circuit Board Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

The circuit board in the MRV-M500 contains all the electrical components necessary to the amplifier's function. A number of issues could cause a circuit board to malfunction and require replacement. To replace the circuit board, you will need a small Phillips screwdriver and a replacement circuit board.

Cosa ti serve

Passo 1 Circuit Board

Alpine MRV-M500 Circuit Board Replacement, Circuit Board: passo 1, immagine 1 di 3

Alpine MRV-M500 Circuit Board Replacement, Circuit Board: passo 1, immagine 2 di 3

Alpine MRV-M500 Circuit Board Replacement, Circuit Board: passo 1, immagine 3 di 3

Remove all the Phillips 10.0mm and 7.0mm screws on the outside of the case.

Traduci

Passo 2

Remove all Phillips 7.5mm, 12.5mm, and 10.5mm screws holding the circuit board to the case.
Make sure the device has been powered off and disconnected from the power source for at least a day before touching the electronic components.

Traduci