Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a PH1 screwdriver bit to remove the six M2.5x13 screws (2.4 mm) on the back of the laptop.
-
Use a PH1 screwdriver bit to loosen the one M2x3 screw (1.9 mm).
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the base cover up to remove it.
-
If you are having trouble, insert a plastic opening tool into the divots along the laptop's edges to loosen.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the battery connector cable, located on the right side of the laptop, above the hard disk drive.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a PH1 screwdriver bit to remove the four M2.5x5 screws (2.4 mm) on the hard disk drive.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently lift the HDD cable to disconnect it from the laptop.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the one M2x3 screw (1.9 mm) using a PH1 screwdriver bit
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the solid state drive towards yourself to prevent damage to the card.
-
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.
Un commento
Is it advised to pull the HDD before pulling the SSD or is this guide just written in a way to cover how to remove both of them?