Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove all the selector knob covers by pulling them off.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using needle nose pliers, remove the washers from the four corner selector knobs.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the device over. Using a Philips #2 screw driver, remove the fourteen 10.3 mm black screws holding the back panel in place.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully flip the device to the front making sure you secure the face plate and the chassis together.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Rotate the device 180 degrees and carefully remove the face plate by slightly lifting the screen side towards you and then sliding the bottom out from under the keys.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using needle nose pliers, grip the top of the spring coil, that is holding down the key, and gently lift the spring away from the key.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the key from the front of the keyboard towards the back in order to remove it completely.
-
Annulla: non ho completato questa guida.
Altre 7 persone hanno completato questa guida.