Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip your laptop over so that the model sticker is facing upward towards the ceiling.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips #1 screwdriver to remove the thirteen 6.5mm screws that secure the back cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a plastic opening tool to gently separate the back cover from the laptop. A snapping sound will be heard as a signal that the clips are being disengaged.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips #1 screwdriver to remove two 4 mm screws that secure the battery.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use your hand to carefully pull out the wiring harness from its port that is located between the battery and the motherboard.
-
Remove the battery from the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a Phillips #1 screwdriver, remove the one 4mm screw that secures the Solid State Drive.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use your hand to pull out the Solid State Drive from the motherboard.
-
You will be pulling the solid state drive out to the left, as it will be connected to the port on the motherboard on its right side. This is opposite the direction that the pictures depict it.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.