Salta al contenuto principale

Introduzione

This guide explains how to remove the solid state drive. Before removing the solid state drive, the back panel assembly needs to be removed. Once the back panel assembly is removed, the solid state drive can be quickly unscrewed and pulled out.

Ricambi

Nessuna parte specificata.

  1. Remove the thirteen 6.0mm screws on the back panel using your Phillips #1 screwdriver. Remove the thirteen 6.0mm screws on the back panel using your Phillips #1 screwdriver.
    • Remove the thirteen 6.0mm screws on the back panel using your Phillips #1 screwdriver.

  2. Pry the back panel open with the plastic opening tool. Pry the back panel open with the plastic opening tool.
    • Pry the back panel open with the plastic opening tool.

  3. Remove the single 3.0mm screw securing the solid state drive using a Phillips #1 screwdriver. Remove the single 3.0mm screw securing the solid state drive using a Phillips #1 screwdriver.
    • Remove the single 3.0mm screw securing the solid state drive using a Phillips #1 screwdriver.

  4. Carefully pull out the solid state drive using two fingers. Carefully pull out the solid state drive using two fingers.
    • Carefully pull out the solid state drive using two fingers.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Jason Bechtold

Membro da: 19/10/2017

564 Reputazione

5 Guide realizzate

Team

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 9

Tutti i Tempi: 412