Introduzione

The motherboard is pretty important. Follow this guide to replace yours.

Locate and remove the two 5.3 mm Phillips #1 screws holding the back panel in place.
  • Locate and remove the two 5.3 mm Phillips #1 screws holding the back panel in place.

Aggiungi Commento

Use a spudger to pry the panel up from the laptop case and remove it.
  • Use a spudger to pry the panel up from the laptop case and remove it.

  • The laptop should now be open with the RAM and wifi chip now accessible.

Aggiungi Commento

  • Locate the wifi chip.

Aggiungi Commento

  • Remove the 5 mm Phillips #1 screw holding the wifi chip in place.

  • Carefully remove the wifi chip.

Aggiungi Commento

  • Remove the 8, 9 mm Phillips #1 screws holding the panel in place.

Aggiungi Commento

  • Flip the computer over, and with a spudger, remove the black panel directly below the keyboard.

  • Remove the panel and flip it up onto the keyboard

Aggiungi Commento

  • With the panel removed, locate the USB port ribbon cable connecting to the motherboard.

  • Carefully disconnect the ribbon cable.

Aggiungi Commento

  • Unscrew the 5 mm Phillips #1 screw holding the USB ports in place.

Aggiungi Commento

  • The USB ports can now be removed from the laptop.

Aggiungi Commento

  • Flip the laptop and remove all 10 of the remaining 9mm screws from the back.

I had to remove 11 screws. The one underneath the battery.

sj.408.shane - Replica

  • Use a spudger to gently lift the keyboard.

The photos for Step 11 show the USB ports still in place. Why did you remove them in Step 9 if it wasn't necessary?

richmaru - Replica

  • Remove the two 10 mm Phillips #1 screws connecting the motherboard to the case.

Aggiungi Commento

  • Disconnect the 4 ribbon cables connected to the motherboard.

  • Some ribbon cable connections may not be accessible until after beginning to lift.

Aggiungi Commento

  • Very carefully lift the motherboard.

  • Do not force the board. If stuck, check that the ports on the left are not stuck, that no wires are still attached, and no screws are still in.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Alexander Lazar

Membro da: 22/04/2014

306 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 8-8, Regan Spring 2014 Membro di Cal Poly, Team 8-8, Regan Spring 2014

CPSU-REGAN-S14S8G8

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 24

Tutti i Tempi: 4,239