Introduzione

You will have to remove several screws and a couple of cables on the bottom of the ZG5 to remove or replace the wireless card.

Parti

Nessuna parte richiesta.

  1. Turn the netbook upside down with the battery at the top, away from you.
    • Turn the netbook upside down with the battery at the top, away from you.

    Aggiungi Commento

  2. Unlock the battery by sliding the switch located near the left hinge to the left "unlocked" position.
    • Unlock the battery by sliding the switch located near the left hinge to the left "unlocked" position.

    Aggiungi Commento

    • Slide the latch located on the opposite hinge from the lock while pushing the battery up.

    Aggiungi Commento

    • Gently loosen the two Phillips #0 screws in the small panel that covers the wireless card.

      • These screws are built into the panel and aren't meant to be completely removed.

    Aggiungi Commento

    • Lift up the panel and remove it from the case.

    Aggiungi Commento

    • Disconnect the two antenna cables from the left side of the wireless card.

    Aggiungi Commento

    • Remove the single 3.9 mm Phillips #1 screw from the bottom left of the wireless card.

    Aggiungi Commento

    • Gently lift up the left side of the wireless card and slide the card out of its socket.

    mi lap NO tiene wireless card

    gustavo cordova - Replica

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 6 persone hanno completato questa guida.

Doug Gallatin

Membro da: 05/10/2010

5.799 Reputazione

10 Guide realizzate

Team

Cal Poly, Team 7-49, Amido Fall 2010 Membro di Cal Poly, Team 7-49, Amido Fall 2010

CPSU-AMIDO-F10S7G49

5 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 6

Ultimi 30 Giorni: 36

Tutti i Tempi: 22,336