Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Introduzione
This guide will show you how to gain access to the LCD Control Board and the Backlight Control Board on an Apple Cinema Display M8149. The tools required for this section are the spudger and the PH 2 screwdriver.
Cosa ti serve
-
-
Place the Cinema Display so that it is lying on its face and the feet are pointed away from you.
-
Locate the three screws that connect the back foot to the hinge. Remove the three screws (9.52 x 4.43mm) using the Hex Key.
-
Remove the back foot from the hinge mount by grabbing the foot and pulling upwards.
-
-
-
Located the large brown plug in the center-right, that connects the control board to the rest of the display and unplug it.
-
Locate on the right side of the control board the blue and gray plug and unplug it.
-
Locate on the left side of the control board the blue and gray plug and unplug it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.
Un commento
thank you for this guide. my 22" adc didn't want to start up. after following this guide, it now works with my G4. thank you