Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

Replacing the circuit in the charging cradle

Parti

Nessuna parte specificata.

  1. Using a metal spudger gently pry the plastic outer case apart Pry open a little bit on each side before trying to open fully Pry open a little bit on each side before trying to open fully
    • Using a metal spudger gently pry the plastic outer case apart

    • Pry open a little bit on each side before trying to open fully

  2. Use the PH0 sized Phillips screwdriver to remove the three screws (2mm) holding the board to the cradle. Gently pry up with your hands to pull the board off. Don't grab directly on the USB port as you may loosen or bust the connections.
    • Use the PH0 sized Phillips screwdriver to remove the three screws (2mm) holding the board to the cradle.

    • Gently pry up with your hands to pull the board off.

    • Don't grab directly on the USB port as you may loosen or bust the connections.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Wayne McClure

Membro da: 10/02/2016

952 Reputazione

5 Guide realizzate

Team

USF Tampa, Team 1-3, Sullivan Spring 2016 Membro di USF Tampa, Team 1-3, Sullivan Spring 2016

USFT-SULLIVAN-S16S1G3

4 Membri

7 Guide realizzate

If you had listed what components were on the board or at least taken a picture of the other side of the board, I might have given you some points.

Nate Fansler - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 6

Tutti i Tempi: 2,501