ASUS Q400A-BHI7N03 Power Jack Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

It is a common issue among ASUS Q400A laptops to refrain from charging. Among battery and charger issues, it is likely that the power jack isn't operating correctly. The following is a guide explaining how to gain access to the power jack for replacement.

Cosa ti serve

Passo 1 Power Jack

ASUS Q400A-BHI7N03 Power Jack Replacement, Power Jack: passo 1, immagine 1 di 1

Flip laptop over with the battery facing toward you.
Slide both tabs with the lock/unlock symbol, near the battery on the right of the notebook, to the unlock position.
Grab the top edge of the battery & lift upward to relieve the battery from its slot.

Traduci

Passo 2

Remove the one black 8mm Phillips #0 screw.
Lift and remove the bottom cover panel using the plastic opening tool.

Traduci

Passo 3

Remove the four 8mm Phillips #0 screws.
Lift and remove the drive.

Traduci

Passo 4

Remove the single silver 8mm Phillips #0 screw.
Remove the three 8mm Phillips #0 screws.

Traduci

Passo 5

Remove the seven black 8mm Phillips #0 screws around the perimeter.
Remove the two silver 8mm Phillips #0 screws that are under the battery.

Traduci

Passo 6

Flip the device right-side up and pry up the keyboard and touchpad gently using both hands.

Traduci

Passo 7

Release the ZIF (zero insertion force) connector using a plastic spudger.
Remove the ribbon cable by hand from the ZIF connector.
Do not use too much force when releasing the ZIF connector.

Traduci

Passo 8

Remove the two remaining ribbon cables as described in Step 7.

Traduci

Passo 9

Unscrew the two black 8mm Phillips #0 screws.
Firmly grasp each antenna head with a pair of blunt tweezers and detach it by lifting up straight.
The antenna cables are connected through small sockets. Small popping sounds when attaching and detaching the antennas are normal.

Traduci

Passo 10

Remove the five black 8mm Phillips #0 screws.

Traduci

Passo 11

Firmly grab the optical drive and remove it by sliding it out.

Traduci

Passo 12

Lift the motherboard gently to completely remove this component from the device.
Detach Audio Cable gently by hand and you have now access to replace the power jack.

Traduci