Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Begin by putting the needle into the hole in the disk tray.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the spudger to help ease out the disk drive.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 3 small screws located underneath the disk drive.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the nine remaining 8 mm Phillips-head screws on the back of the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the opening tool to pry the back of the laptop case from the top
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the 3 cables connecting the motherboard to the keyboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the two 8mm screws attached to the battery
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the bundled cable connector and remove the battery.
-
Annulla: non ho completato questa guida.
Altre 20 persone hanno completato questa guida.
5 Commenti
Thank you for your help, I now know how to change the battery, I tried disconnecting and reconnecting it see if I would get any power at all but zip, I will look on Ebay to try and buy a battery for it but I hope it’s that as it was working fine then said battery had no charge when I always made sure it never ran out so not sure what the problem was, at first I thought it was the chord but wasn’t that as I changed it.
I have added comments to steps 5, 6, and 7. The biggest piece of advice is just to make sure you have all 20 screws removed before trying to remove the keyboard (the guide does NOT mention all 20 of these screws). This might be more than necessary but I felt safer removing them than risking snapping one of the plastic clips that holds the keyboard in place.
Dont forget to put the three screws back in the frame prior to putting the optical drive back in and dont forget to put the battery screws back in, other than that a great guide.