Salta al contenuto principale

Introduzione

This guide will show you how to replace the joystick component on the 8Bitdo N30 Arcade Stick.

  1. Turn the device over so that the bottom is facing up. Turn the device over so that the bottom is facing up.
    • Turn the device over so that the bottom is facing up.

  2. Use a Phillips #0 screwdriver to remove all ten of the 3 mm screws on the back plate.
    • Use a Phillips #0 screwdriver to remove all ten of the 3 mm screws on the back plate.

  3. Remove the rubber slider as indicated in the picture to assist in removing the back panel. Hold the arcade stick and pry the back panel away from the device until it comes off.
    • Remove the rubber slider as indicated in the picture to assist in removing the back panel.

    • Hold the arcade stick and pry the back panel away from the device until it comes off.

    • Remember the position of the rubber slider. This will be replaced at the end of the process.

  4. Locate the back piece of the joystick. Remove the four screws that secure the joystick to the plate using the Phillips #0 screwdriver.
    • Locate the back piece of the joystick.

    • Remove the four screws that secure the joystick to the plate using the Phillips #0 screwdriver.

  5. Use a flathead screwdriver to unscrew the middle screw that holds the ball piece onto the joystick. Remove the ball piece and set it aside.
    • Use a flathead screwdriver to unscrew the middle screw that holds the ball piece onto the joystick.

    • Remove the ball piece and set it aside.

    • Be sure to hold the ball piece in place while turning the screw counterclockwise.

    • When attaching the new joystick and ball piece, turn the screw clockwise while holding the ball piece in place.

  6. Locate the joystick wires that are attached to the four indicated plugs on the motherboard, and remove them. In fine print, "left", "down", "up", and "right" are found above the wires that need to be removed. Take caution and gently disconnect the wires.
    • Locate the joystick wires that are attached to the four indicated plugs on the motherboard, and remove them.

    • In fine print, "left", "down", "up", and "right" are found above the wires that need to be removed.

    • Take caution and gently disconnect the wires.

  7. Remove the back piece from the mounting plate. Replace the joystick's back piece.
    • Remove the back piece from the mounting plate.

    • Replace the joystick's back piece.

Conclusione

For the new joystick, follow the steps in reverse order. Once again, don’t forget the rubber slider for the back panel.

Boot up your favorite PC or Nintendo Switch fighting game and make sure your joystick works!

Un'altra persona ha completato questa guida.

looks just like the mayflash f300

Jon Hernandez - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 12

Ultimi 30 Giorni: 37

Tutti i Tempi: 599