Salta al contenuto principale

3DR Solo Leg Replacement

Cosa ti serve

  1. 3DR Solo Leg Replacement, Propeller: passo 1, immagine 1 di 1
    • Grip the arm, which is located underneath the propeller, with one hand, and with your dominant hand grip the center of the propeller.

  2. 3DR Solo Leg Replacement: passo 2, immagine 1 di 1
    • Twist the propeller from the locked to unlocked position as indicated by the images of the lock.

    • You will need to twist in this direction for 2-3 full rotations before the propeller will detach.

  3. 3DR Solo Leg Replacement: passo 3, immagine 1 di 1
    • Lift the propeller off the motor.

    • To remove the silver-top propellers, repeat these steps, turning the propellers in the opposite direction of the black-top propellers.

  4. 3DR Solo Leg Replacement, Leg: passo 4, immagine 1 di 1
    • Place the controller on a flat surface with the battery side down.

  5. 3DR Solo Leg Replacement: passo 5, immagine 1 di 3 3DR Solo Leg Replacement: passo 5, immagine 2 di 3 3DR Solo Leg Replacement: passo 5, immagine 3 di 3
    • Locate the leg and remove the two 10mm screws that hold the leg in place.

  6. 3DR Solo Leg Replacement: passo 6, immagine 1 di 1
    • Gently pull the leg up to remove it from its position.

    • Leg should be connected by a black wire.

  7. 3DR Solo Leg Replacement: passo 7, immagine 1 di 3 3DR Solo Leg Replacement: passo 7, immagine 2 di 3 3DR Solo Leg Replacement: passo 7, immagine 3 di 3
    • Locate the rubber grip at the end of the leg and, with your thumb, peel it back and pull it off.

  8. 3DR Solo Leg Replacement: passo 8, immagine 1 di 2 3DR Solo Leg Replacement: passo 8, immagine 2 di 2
    • Leg type 1 will contain a 1mm screw at the base of the leg.

    • Unscrew the 1mm screw located at the end of the leg.

  9. 3DR Solo Leg Replacement: passo 9, immagine 1 di 1
    • Gently pull the black cord up to release it from the leg.

  10. 3DR Solo Leg Replacement: passo 10, immagine 1 di 3 3DR Solo Leg Replacement: passo 10, immagine 2 di 3 3DR Solo Leg Replacement: passo 10, immagine 3 di 3
    • Leg type 2 will contain the antenna wire.

    • Gently pull up on and remove the plastic covering labeled "solo antenna".

    • Locate the antenna wire and carefully pull up and remove it.

    • The antenna wire is flimsy so use caution upon removal.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Leia Harlow

Membro da: 09/11/17

101 Reputazione

1 Guida realizzata

Team

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 321