Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

  1. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Flip the camera upside down and peel off the two plastic screw covers with the metal spudger to reveal the screws.
    • Flip the camera upside down and peel off the two plastic screw covers with the metal spudger to reveal the screws.

  2. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Remove the two 5 mm screws from the bottom of the camera with a T4 screwdriver.
    • Remove the two 5 mm screws from the bottom of the camera with a T4 screwdriver.

  3. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Gently pry the plastic ring from around the charging plate with the metal spudger. Remove the outside shell by pressing against the center of the charging plate and pulling the bottom shell away from the top shell.
    • Gently pry the plastic ring from around the charging plate with the metal spudger.

    • Remove the outside shell by pressing against the center of the charging plate and pulling the bottom shell away from the top shell.

  4. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Remove the five 2 mm screws using a T4 screwdriver.
    • Remove the five 2 mm screws using a T4 screwdriver.

    • Pull off the charging plate assembly.

  5. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Gently pry the plug off the port on the circuit board with a plastic opening tool. Remove the four 2 mm screws using a T4 screwdriver.
    • Gently pry the plug off the port on the circuit board with a plastic opening tool.

    • Remove the four 2 mm screws using a T4 screwdriver.

    • Remove the circuit board from the device.

  6. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Remove the five 4 mm screws around the battery assembly with a T4 screwdriver. Lift the battery assembly and gently pry the plug out of its port on the board below with a plastic opening tool. Press the battery from the back  of the battery assembly to remove it with a plastic opening tool until the glue releases the battery.
    • Remove the five 4 mm screws around the battery assembly with a T4 screwdriver.

    • Lift the battery assembly and gently pry the plug out of its port on the board below with a plastic opening tool.

    • Press the battery from the back of the battery assembly to remove it with a plastic opening tool until the glue releases the battery.

    • Potential for device damage: Do not puncture or bend the battery. Use a small amount of heat to assist in softening the adhesive if necessary.

Linea Traguardo

Altre 2 persone hanno completato questa guida.

Jacob Herron

Membro da: 08/11/2017

421 Reputazione

3 Guide realizzate

Team

IUPUI, Team S5-G3, Baechle Fall 2017 Membro di IUPUI, Team S5-G3, Baechle Fall 2017

IUPUI-BAECHLE-F17S5G3

3 Membri

3 Guide realizzate

Wich one battery Can I use to replace It?

Marco Pereira - Replica

Where can i purchase a battery

john hernandez - Replica

I would like to purchase a 360 fly battery

john hernandez - Replica

Where can I buy the battery?

Mark - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 28

Tutti i Tempi: 1,450