360fly 4K Battery Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

This page will guide you on the replacement of the battery on your 360fly 4K camera.

Cosa ti serve

Passo 1 Battery

360fly 4K Battery Replacement, Battery: passo 1, immagine 1 di 1

Flip the camera upside down and peel off the two plastic screw covers with the metal spudger to reveal the screws.

Traduci

Passo 2

Remove the two 5mm T4 screws from the bottom of the camera with a t4 screw driver.

Traduci

In the older model for Fly360 camera, the screws are PH000.

Renjamin - 29 set 2021 Replica

In the old 360Fly HD camera, the screw requires a #00 Philips head screwdriver. Unfortunately for me, one of the screws on mine was torqued down a bit too tight, that I ended up stripping the screw head trying to loosen it by hand.

XzTS - 20 apr 2022 Replica

Passo 3

Gently pry the plastic ring from around the charging plate with the metal spudger.
Remove the outside shell by pressing against the center of the charging plate and pulling the bottom shell away from the top shell.

Traduci

Passo 4

Remove the five 2mm T4 screws and pull off the charging plate assembly with the t4 screw driver.

Traduci

Passo 5

Gently pry the plug off the port on the circuit board with a plastic opening tool.
Remove the four 2mm T4 screws and take off the circuit board with a T4 screw driver.

Traduci

Passo 6

360fly 4K Battery Replacement: passo 6, immagine 3 di 3

Remove the five 4mm T4 screws around the battery assembly with a t4 crew driver.
Lift the battery assembly and gently pry the plug out of its port on the board below with a plastic opening tool.
Press the battery from the back of the battery assembly to remove it with a plastic opening tool until the glue releases the battery.
Do not puncture or bend the battery. Use a small amount of heat to assist in softening the adhesive if necessary.