Introduzione

This guide is applicable for any Accord made between 1998 and 2002.

  1. Before going any further: disconnect the battery. I keep a 10 mm wrench in my center console specifically for this purpose.
    • Before going any further: disconnect the battery. I keep a 10 mm wrench in my center console specifically for this purpose.

    • Use a 10 mm wrench to disconnect the negative battery terminal, followed by the positive terminal.

    Aggiungi Commento

  2. Note that the dash has been taken apart before, namely to install all those fancy gizmos you see in this picture.
    • Note that the dash has been taken apart before, namely to install all those fancy gizmos you see in this picture.

    • The disassembly procedure is exactly the same for stock factory systems, but may differ when taking out the radio itself.

    Aggiungi Commento

    • Use a #2 Philips screwdriver to remove the two screws holding the center of the dashboard in place.

    Aggiungi Commento

    • Use a spudger for the following step or, if you don't have one handy, cover a flathead screwdriver with a rag.

    • Gently insert a spudger or flathead screwdriver directly underneath the clock, just enough so you can pry out the clock. Perhaps a half inch or so will do it.

    Aggiungi Commento

    • Slide the clock out to expose a sole Phillips screw.

    • Alternatively, you can first disconnect the clock (see next step) and then proceed to remove the screw. It might be slightly easier to do that instead of the method you see here, but either way will work fine.

    • Remove the screw using your Phillips #2 screwdriver.

    Aggiungi Commento

    • Unplug the smaller connector first. There's a tab on top of the connector that you have to push downwards, then pull the connector. Make sure to grasp the connector itself, and not the wires.

    • Do the same with the larger connector. Again, there's a tab on top that needs to be pushed downward.

    Aggiungi Commento

    • Now, gently pull the bottom of the center console towards you. Don't yank it out, there's two more connectors holding it in place.

    Aggiungi Commento

    • First take off the red connector. Just like before, there's a tab on top of the connector that you have to push downwards first.

    • Follow suit with the green connector.

    • Center dash can now be fully removed.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 7 persone hanno completato questa guida.

Excellent Instructions. Toughest part is prying off the panel once you remove the screws and clock. The power connectors to the controls, (Hazards, Clock, Climate Control) can be a little tough too, wiggling helped.

Jason - Replica

My car radio is deactivated

Amelia davila - Replica

I need the inside lighting fixture on the front top of the dash

Robert Jones - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 32

Ultimi 30 Giorni: 130

Tutti i Tempi: 28,312