Introduzione

Checking the fluid levels on your car can significantly increase its life. Maintaining the correct fluid levels will prevent engine component failures.

Strumenti

Parti

Nessuna parte richiesta.

  1. Use caution while handling brake fluid. Brake fluid strips paint and dissolves plastic.
    • Use caution while handling brake fluid. Brake fluid strips paint and dissolves plastic.

    • There is a maximum fluid line on the right side of the reservoir. Remove the brake fluid cap and fill the brake fluid to the maximum level line.

    Aggiungi Commento

  2. Do not overfill the power steering fluid reservoir, as this can overwork the power steering pump and cause it to burn up.
    • Do not overfill the power steering fluid reservoir, as this can overwork the power steering pump and cause it to burn up.

    • Remove the power steering fluid cap. Check the fluid level using the dipstick attached to the cap.

    • Fill the power steering fluid to the appropriate level indicated by the "H" for hot and the "C" for cold.

      • If the car has not been started then the fluid is cold. If the engine has been running for five minutes or more, then it is hot.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Use the yellow handled oil dipstick to check the oil level by removing the dipstick, wiping off the oil, and re-inserting it.

    • Remove the dipstick again and check the oil level. Full level is read on the right side of the dipstick.

    Aggiungi Commento

    • If the oil level is below full, add oil to the car by removing the cap labeled "Engine Oil."

    • Add a small amount of oil and repeat Step 3 until the oil level is full.

    Aggiungi Commento

    • Make sure the engine is cool before removing the radiator reservoir cap. Radiator coolant needs to be disposed of properly. Visit this link for more information http://www.epa.gov/osw/conserve/material...

    • Remove the radiator reservoir cap and fill it with coolant until it reaches the full level indicator line on the front side of the reservoir.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 7 persone hanno completato questa guida.

Sank Yang

Membro da: 03/10/2012

345 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 9-15, Amido Fall 2012 Membro di Cal Poly, Team 9-15, Amido Fall 2012

CPSU-AMIDO-F12S9G15

4 Membri

5 Guide realizzate

GM does not want purchasers of used cars to check transmission fluid levels.

Hoping you run it dry so things blow up and you have to buy a new vehicle.

Beginning to dislike GMs

Randy Oman - Replica

I been trying to figure out why the cars shaking so i changed the spark plugs now it shake small kind now the airfilrt needs to be changed out as well but whats with the gas smell when turning on?

Bruce allen - Replica

I am trying to change my starter on my 1997 Malibu Chevrolet SD 2.1L but I am not sure if I can take it out from the top or it's best to go from the bottom? Need to know ASAP.

Renee Howington - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 9

Ultimi 7 Giorni: 60

Ultimi 30 Giorni: 274

Tutti i Tempi: 27,903