Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Before beginning, ensure that your model does not contain an airbag behind the steering wheel. Then, disconnect your car battery.
-
Pull off your horn button and locate the horn wire. Once found, twist the plastic keeper to remove.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the six "torx head" screws that hold the steering wheel to the steering wheel hub. Removing the screws is not necessary but will make the job easier.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the steering shaft nut and pull off the steering hub. A steering wheel puller may be required. Use caution as the steering hub may pop loose. Next, remove the two "torx head" screws behind the steering hub that hold the two plastic covers together.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the top half of the plastic cover with a strong pull.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using locking pliers, unscrew the tilt-adjusting lever. Wrap a shop towel or dish cloth around the lever to prevent scratches.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three "torx head" screws to release the plastic cover from the steering column.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Sit in the car facing the steering wheel. Lean to the left to locate the two "torx head" screws on the ignition. Remove these.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a flat head screwdriver, test the new switch. Do so by reconnecting the battery and turning the switch in either direction. The switch should turn smoothly and only kick back to the on position. After testing, disconnect the battery again. Take note of the tab on the case of the switch.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Tab A goes into slot B, marked in the photo. Also note that just above the red circle is the end of the ignition lock cylinder in the off position. If yours is not in the off position, it should be.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Repeat the steps in opposite order to put the steering wheel back together.
-
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.
5 Commenti
How to change out the key switch 94 Cavalier
Quick and easy fix! Thanks!
Where can get a replacement ignition switch? Do stores carry them??
how do you get the switch cylinder out of column
Hey, I have a 1991 Chevy Cavalier and sometimes the windshield wipers/radio/clock don't work. Does this sound familiar? Trying to understand what parts I may need to order to corect this.