Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull straight up on the ignition coil wire in the center of the distributor cap to disconnect it.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull straight up on the boot of the first spark plug wire to disconnect it from the distributor cap.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Install the spark plug wire onto the new distributor cap and make sure it is seated properly.
-
Continue to transfer each spark plug wire to the new distributor cap, maintaining the same arrangement of wires on the cap.
-
Once all of the spark plug wires have been installed on the new distributor cap, set the cap aside.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a flathead screwdriver to release the clip securing the distributor cap.
-
Remove the old distributor cap.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.