Service Bulletin

Technical Bulletin

SERVICE

Classification:

EC17-022

Reference:

NTB17-091

NISSAN NORTH AMERICA, INC.

Date:

August 8, 2017

2013-2017 ALTIMA AND 2014-2017 ROGUE; MIL ON WITH DTC P2004 STORED

APPLIED VEHICLES:

2013-2017 Altima (L33)

2014-2017 Rogue (T32)

APPLIED ENGINE:

QR25DE

IF YOU CONFIRM

MIL is ON with P2004 (INTAKE MANIFOLD RUNNER CONTROL VALVE POSITION SENSOR) stored.

And

There are no drivability issues.

ACTION

1. Remove the intake manifold.
2. Replace the intake manifold runner control valve position sensor.
3. Re-install intake manifold.

IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.

Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.

SERVICE PROCEDURE

IMPORTANT: Follow all cautions, warnings, and notes in the Electronic Service Manual (ESM) when working on or near the vehicle fuel system.

1. Turn the ignition ON, engine OFF.
2. Record (write down) any customer settings that will be lost when the battery is disconnected.
3.  Refer to the ESM, section PG - Power Supply, Ground & Circuit Elements / ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL , for a listing of systems that may lose settings or memory when disconnecting the 12V battery.
4.  This list often includes items such as, HVAC, power windows, clock, etc.
5. Turn the ignition OFF.
6. Disconnect the negative terminal of the vehicle 12V battery.
7.  Refer to the ESM, section PG-Power Supply, Ground, & Circuit Elements , for procedure to disconnect the 12V battery.

Table Caption: This table appears to be a configuration or settings matrix for an audio system, possibly a car stereo or home theater, with different presets (1-6) and adjustable parameters like AM/FM radio, satellite channels, and audio adjustments such as Bass, Treble, Balance, Fade, and Speed Volume.

5. Remove the intake manifold.
6.  Refer to the ESM, section EM - Engine Mechanical , for the procedure to remove the intake manifold.
7. Remove the 'intake manifold runner control valve position sensor' (position sensor) from the intake manifold.

• a. Remove two (2) Torx bolts.
• b. Removed position sensor.

7. Install the new position sensor onto